Just purchased HomeSeer with ACT TI103 to control my old X10 setup.
Can't make it to work.
- Installed TI103 plug-in
-Enabled it on COM1
-It seems to initialize properly
Extracted message from log:
... Initializing plug-in: ACT TI103
... TI103 Plug-in, Version 2.0.5
When adding a new device I don't see any Device Type related to TI103. I only see generic Lamp Module or Appliance Module.
What is it that I am missing ?
Can't make it to work.
- Installed TI103 plug-in
-Enabled it on COM1
-It seems to initialize properly
Extracted message from log:
... Initializing plug-in: ACT TI103
... TI103 Plug-in, Version 2.0.5
When adding a new device I don't see any Device Type related to TI103. I only see generic Lamp Module or Appliance Module.
What is it that I am missing ?
Comment