You should have an instruction document in the Docs subfolder of your Homeseer folder. There is a section there that describes adding security devices. It's page 8 in the document I have. You'll need to read through it a couple of times and follow the instructions carefully. I found that the first time it was a bit confusing, but once I understood, it turns out to be pretty easy.
Abridged version to register your MS10: Choose the ACRF plug-in from the Plug-Ins tab, then select the Sec. Devices tab. Then click on the Add button at the bottom. You will get a screen like that below. Select the supervised motion sensor (I'm pretty sure the MS10 is a supervised sensor). Give the device a name and a location that will appear on the device in HS. I have no experience with the MS10, but I assume there is a Test button or something similar. When you are ready, press and release that button, then (after you press the button) tick the box that says 'Auto-fill code...' That should populate the Device ID box with the unique code generated by your MS10.
Once the information on the page is all in place click on the Add button. That should take you back to the previous page where your MS10 will now be listed. You are almost done. There is one more critical step.
BE SURE TO PRESS THE Save Changes BUTTON !!!!!!!!!!!
Warning - This is from memory. Be sure to read the instructions, especially if it doesn't work the first time. (That's how I do it, anyway. )
Abridged version to register your MS10: Choose the ACRF plug-in from the Plug-Ins tab, then select the Sec. Devices tab. Then click on the Add button at the bottom. You will get a screen like that below. Select the supervised motion sensor (I'm pretty sure the MS10 is a supervised sensor). Give the device a name and a location that will appear on the device in HS. I have no experience with the MS10, but I assume there is a Test button or something similar. When you are ready, press and release that button, then (after you press the button) tick the box that says 'Auto-fill code...' That should populate the Device ID box with the unique code generated by your MS10.
Once the information on the page is all in place click on the Add button. That should take you back to the previous page where your MS10 will now be listed. You are almost done. There is one more critical step.
BE SURE TO PRESS THE Save Changes BUTTON !!!!!!!!!!!
Warning - This is from memory. Be sure to read the instructions, especially if it doesn't work the first time. (That's how I do it, anyway. )
Comment