I have 6 CT 30s in a vacation home. They run on batteries and control heat only. When I access via HSTtouch iPhone, I can see the "all devices" list screen with correct temps. If I drill down on either garage or rec room, I see the correct readings on the tstat and have control of the device.
Drilling down on the other 4, however, yields a large "NA" on the tstat image and I have no device control. The log says:
2/23/2014 7:28:13 AM ZWave Thermostats Error in HSPI.NTemps, Object reference not set to an instance of an object.
2/23/2014 7:28:13 AM ZWave Thermostats Error in StatName, Object reference not set to an instance of an object.
I can successfully scan, optimize and full optimize the problem devices and VNC sees and operates the device.
I am a thousand miles away from this home. Any suggestions?
Drilling down on the other 4, however, yields a large "NA" on the tstat image and I have no device control. The log says:
2/23/2014 7:28:13 AM ZWave Thermostats Error in HSPI.NTemps, Object reference not set to an instance of an object.
2/23/2014 7:28:13 AM ZWave Thermostats Error in StatName, Object reference not set to an instance of an object.
I can successfully scan, optimize and full optimize the problem devices and VNC sees and operates the device.
I am a thousand miles away from this home. Any suggestions?
Comment