Never mind - I was able to replicate on my own system and work it out.
It was a mess - the plug would get stuck during the start-up due to some dodgy code which has been there for a while - when you stop the plugin, it wouldn't actually stop and you could end up with multiple instances of the thing running.
I've created and tested a new version which fixes this for good. This one actually allows you to set the IP address in the config page. Should be in updater soon under version 2.1.8.12
in the mean time for anyone reading this - just edit the HSPI_Opensprinkler.ini file to set the correct IP and port and it will work just fine.
I've also added support for the flow sensor, however i'm not sure i have the scaling correct - need someone to test for me.
Cheers.
It was a mess - the plug would get stuck during the start-up due to some dodgy code which has been there for a while - when you stop the plugin, it wouldn't actually stop and you could end up with multiple instances of the thing running.
I've created and tested a new version which fixes this for good. This one actually allows you to set the IP address in the config page. Should be in updater soon under version 2.1.8.12
in the mean time for anyone reading this - just edit the HSPI_Opensprinkler.ini file to set the correct IP and port and it will work just fine.
I've also added support for the flow sensor, however i'm not sure i have the scaling correct - need someone to test for me.
Cheers.
Comment