I have a Hometroller-Zee with Z-Stick. I also can run HSTouch.
I have found where to set up a Scene, but I don't see any way to use it. I'm working on a new application with the same hardware where I need set up Z-Wave switches that control other switches, and need to be able to set up scenes for the entire mass. These are the house lights at church. The main switches are all in, the controller goes in this week, and I'm experimenting on my home setup to figure out what I need to do next.
I need Scenes for things like:
All ON (though one light needs to be at about 50% - maybe this should be All Max, with a max set for each switch)
Dim to 80% (keep the one light at 50%)
Dim to xx% (keep the one light at 50% unless xx is less than 50)
All OFF (or dim to 0%)
I'm then likely to need more.
What I need, though, is a user friendly way to trigger these Scenes, and I don't see that with either HS3 or HSTouch. What am I missing??
David
I have found where to set up a Scene, but I don't see any way to use it. I'm working on a new application with the same hardware where I need set up Z-Wave switches that control other switches, and need to be able to set up scenes for the entire mass. These are the house lights at church. The main switches are all in, the controller goes in this week, and I'm experimenting on my home setup to figure out what I need to do next.
I need Scenes for things like:
All ON (though one light needs to be at about 50% - maybe this should be All Max, with a max set for each switch)
Dim to 80% (keep the one light at 50%)
Dim to xx% (keep the one light at 50% unless xx is less than 50)
All OFF (or dim to 0%)
I'm then likely to need more.
What I need, though, is a user friendly way to trigger these Scenes, and I don't see that with either HS3 or HSTouch. What am I missing??
David
Comment