Event Triggers

[S-F]

Could you post a screenshot of your options?

Check mine out.

[macrho]

I don't see a way to use the status, only the value is available

[S-F]

Your trigger of custom value seems to be the issue. It should be changes and becomes On/Open/Motion or Off/Closed/No Motion as your log shows. I don't have this device so I can't tell you exactly what it should be but something like that.

[macrho]

I'm missing something really basic.

I have an EcoLink Tilt Sensor on my right garage door. I'm utilizing the two statuses that are attached to the sensor:

1) Off-Closed-No Motion status with a value of 0
2) On-Open-Motion status with a value of 255

I can see that these events fire in my log:

Device: Outside Garage Sensor Binary Reserved Set to On/Open/Motion
Device: Outside Garage Sensor Binary Reserved Set to Off/Closed/No Motion

So it appears when I'm opening and closing the garage door, I'm getting notice that these events happened. So far, so good.

My open event is setup as:

IF This device changes and becomes...
Outside Garage Right Tilt Sensor changes and becomes a custom value or value range of 255 to 255

and my close event is setup as

IF This device changes and becomes...
Outside Garage Right Tilt Sensor changes and becomes a custom value or value range of 0 to 0

The THEN piece is sending a pushover message

If I run each of the events by clicking on the Play icon, I receive my pushover message, as expected, so I know that piece works.

When my garage door tilt sensors change, I get no pushover notification

What did I do wrong?