Phantom Insteon link

[mbirrell]

Hi Folks,

I have an Insteon hub, Insteon Motion and an Insteon Wall Relay plug. I configured the motion to switch on the relay witch worked well. I have installed Homeseer on a Raspberry Pi and got the whole lot working. The silly thing I did though was I force removed the Motion from the hub without deleting the link. The problem is now I can't seem to get rid of the link between the Motion and the relay plug. I have reset the relay plug and the motion sensor to factory defaults but that hasn't helped. The only thing I haven't tried is a hammer. My question is how to I stop the motion sensor from controlling my relay plug?

regards,

Martin

[mbirrell]

Hi Folks,

I have an Insteon hub, Insteon Motion and an Insteon Wall Relay plug. I configured the motion to switch on the relay witch worked well. I have installed Homeseer on a Raspberry Pi and got the whole lot working. The silly thing I did though was I force removed the Motion from the hub without deleting the link. The problem is now I can't seem to get rid of the link between the Motion and the relay plug. I have reset the relay plug and the motion sensor to factory defaults but that hasn't helped. The only thing I haven't tried is a hammer. My question is how to I stop the motion sensor from controlling my relay plug?

regards,

Martin

Ok I have fixed the problem.... I edited the Insteon wall relay links in Homeseer and removed the link.... the only thing I didn't try because of the warning in doing so on the page.