No announcement yet.

Preset Dim with CM11A in HS3?

  • Filter
  • Time
  • Show
Clear All
new posts

    Preset Dim with CM11A in HS3?

    I need to send PreSet Dim commands. In HS2 that was easy to do, but in HS3, even when I choose PreSet as Device Type on the X10 tab I get a template for continuous dimming.

    I can change the setup to single values, but when I send a value (3 for example), an All Units Off command is sent instead of a PreSet Dim command.

    Is this a bug? Do I need to do something different? Do I need to use a different interface?
    Mike____________________________________________________________ __________________
    HS3 Pro Edition, NUC i3

    HW: Stargate | NX8e | CAV6.6 | Squeezebox | PCS | WGL 800RF | RFXCOM | Vantage Pro | Green-Eye | Edgeport/8 | Way2Call | Ecobee3 | EtherRain | Ubiquiti