Announcement

Collapse
No announcement yet.

Problems optimizing Merten Gen1 z-wave nodes

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Guest's Avatar
    Guest replied
    Originally posted by TomTom View Post
    Right now don't optimize any more, there is a clog and its just getting further clogged and messing up the routing due to the clogs.

    Ok first go to
    Plugins > Z-wave > Controller Management > Click your Controller/Interface > Test Node Connectivity on a Network.

    What do you see?
    Result of the testing node connectivity: All nodes were successfully contacted!

    Leave a comment:


  • TomTom
    replied
    Right now don't optimize any more, there is a clog and its just getting further clogged and messing up the routing due to the clogs.

    Ok first go to
    Plugins > Z-wave > Controller Management > Click your Controller/Interface > Test Node Connectivity on a Network.

    What do you see?

    Leave a comment:


  • Guest's Avatar
    Guest started a topic Problems optimizing Merten Gen1 z-wave nodes

    Problems optimizing Merten Gen1 z-wave nodes

    I have a large z-wave installation with some old (Gen1) Merten z-wave devices.

    Since i switched vom Z-Stick II to z-wave.me uzb stick optimzing these old devices is not very satisfactory. ( I tried a Z-NET first)

    There are different results when optimizing the system from the controller page or from the device page!
    Some switches are on the same place, but have a different number of neighbors.
    Some switches are near to the UZB but have no direct route.
    Some devices optimized yesterday had a direct route to the uzb stick. After optimizing today node 1 (uzb) disappear!
    With the same device a connectivity test says: Successfully sent a frame to node 7 (EG Kleiner Besprechungsraum Wandschalter) which was acknowledged.
    When I start optimizing i get: Optimize encountered an error, device may not be communicating.
    I did a rescan, i exclude / reset / include a device. All these problems only with the old Gen1 devices.

    I use z-wave 3.01.54

Working...
X