Announcement

Collapse
No announcement yet.

Is there a way to edit and change NODE #'s

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Is there a way to edit and change NODE #'s

    Hi, new to HomeSeer. Just bought and am learning about HomeTroller Zee S2 running HS3. I have been practicing adding and then removing Z-wave nodes, then adding again. Each time it ups the Node # by one. Now that things have settled a bit, it would be clean to have my devices numbered in order. Is there a way to edit the node numbering scheme so I can start again with say 1, 2, 3 and so forth??? Node 1 is the HomeTroller itself but now my other Z-wave devices all have nodes with higher numbers than 2. Any way to edit and change them to lower numbers???

    thanks

  • #2
    No, the nodes are assigned in order till it eventually rolls over and starts to use the empty slots again.
    -Rupp
    sigpic

    Comment


    • #3
      Much appreciated... thanks... bob

      Comment

      Working...
      X