Announcement

Collapse
No announcement yet.

Fibaro dimmer association

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Fibaro dimmer association

    I've just added 2 Fibaro dimmers but am having problems with the associations.

    I want switch 2 on each switch to control switch 1 on the other, I managed to do this without any problems on the original version of the Fibaro dimmers but not these.

    From what I can see on page 17 of the PDF I should be associating Group 4 to Endpoint 2 or Group 5 to Endpoint 3 on both units but I only have the option for Endpoint 1 or 2.

    Any help appreciate :-)

    http://www.fibaro.com/manuals/en/FGD...-EN-T-v1.0.pdf
    Attached Files

    #2
    Strangely it is actually working now but there are no associations showing except for the Homeseer ones, no direct associations between devices.

    I've not setup anything in HomeSeer that would make it work, so I'm a bit confused!

    Update:
    I've figured out that if I click on Audit This Node it then returns and shows the associations.
    Configuring Group 4 on each switch to the required Device and leaving the Destination Endpoint set at No Endpoint works and shows up without any problems.
    Last edited by Simonk; April 8, 2016, 12:39 PM. Reason: Update

    Comment

    Working...
    X