Announcement

Collapse
No announcement yet.

Hometroller SEL and WD-200+ Z-Wave Setting Confusing

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hometroller SEL and WD-200+ Z-Wave Setting Confusing

    When I configure my WD-200+ (firmware 5.14) using my SEL, under the Z-Wave Setting tab, there is a "Bottom LED Operation" setting. It give you two options:
    1. Off if Load is On
    2. On if Load is On (default)

    What it REALLY means is:
    1. Turn the bottom LED light on if the switch is off
    2. Turn the bottom LED light off if the switch is off

    Is anyone else super confused by this??

  • #2
    I was until I tried the option and then it made sense.
    -Rupp
    sigpic

    Comment

    Working...
    X