Announcement

Collapse
No announcement yet.

WS100+ WD100+ no load

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    WS100+ WD100+ no load

    I couldn't find an answer to this simple question.

    Can I wire the homeseer switches with no load? I would do this to use the scene control.

    I'll try disconnecting the load from an existing switch and see what happens if no one knows the answer to this. I think the product documentation says it needs a load.

    I'm not sure though. I actually wired one of my switches to a phantom load. There is a load wire but neither myself of the guy who built the house knows where it goes. Probably opens the neighbors garage, LOL.

    #2
    I'm using a WS100+ without a load attached. Seems to work fine.

    Comment


      #3
      WS100+ and WD100+ both worked fine with no load. Decided to replace my inline volume dial knob with a dimmer integrated as the volume level.

      Volume starts off slow and ramps up quicker as you go higher. Used spuds easy trigger to do that.

      Added no load dimmer and then created event to set the volume level on my kitchen speakers to an expression of the dimmer value. Code below if dimmer is device 123.

      if($$DVR:123: = 0, 0, $$DVR:123: / (5-.04* $$DVR:123)

      Comment

      Working...
      X