I have several WD100+ dimmers with firmware 50.4. On the Z-Wave Settings page, there is a setting to select a Low Dimming Threshold. The values are either "Standard" or "Lowest". However, when I select "Lowest" and then click on "Set", the "Lowest" setting does not "stick" - i.e., the page still reports they are at "Standard". Does anybody know how to get the "Lowest" setting to stick?
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.