HS-WD200+ “Sleeping”

[j2theimi]

I added 2 more Z-Wave devices to my network last night, and noticed that after that my HS-WD200+ was not responding. it was more then not responding, it wasn’t showing up in my node list? When I try to test it or rescan it says that the device needs to be manually woken up...
What happened?

[jvm]

I don't know "what happened" but I've also seen that behavior with some devices. i think it goes away on reboot, but if not on reboot, on an "Audit", "Rescan" or "Restart This Interface" from the Z-Wave Interface management page -- I don't remember which cured it, but one of these did without having to remove and re-add the node. Good luck.