Can't remove bad WD200

[Tomgru]

Hey all... have a failed WD200 i'm trying to replace with identical unit. have tried "replace node", and "remove bad node", and get the following in the log.
ZNetv2: Node 64 was not removed because the interface ZNetv2 does not have that node in its memory. (It may already be removed.)

But in the znet node information, node 64 is clearly still there.

Have also just tried to exclude... but doesn't seem to see the dimmer.

Thoughts on how to remove/replace this that i missed?

[Tomgru]

EDIT: more searching found similar. Going to try this:

Install the new device, click on Replace Node and when the UI asks you, you will then send the inclusion signal on the new device.

When done, the new device will have taken the place of the old device and all HS devices wil be retained.

[prsmith777]

On HS3, I have had this problem.

If you can see the device in Homeseer, go to Zwave then hit "test connectivity". Then try to remove bad node. Sometimes it takes a few trys to get this to work.

If you already deleted the device from homeser, then go to Zwave controller management page and hit "Import Node Info from Controller and Scan Devices". This should bring back the device in question... then repeat above steps.

Not sure if this is HS4

[Tomgru]

Crap... that still didn't work. Same error with new dimmer installed..

[Tomgru]

On HS3, I have had this problem.

If you can see the device in Homeseer, go to Zwave then hit "test connectivity". Then try to remove bad node. Sometimes it takes a few trys to get this to work.

If you already deleted the device from homeser, then go to Zwave controller management page and hit "Import Node Info from Controller and Scan Devices". This should bring back the device in question... then repeat above steps.

Not sure if this is HS4

thanks... that worked.