Announcement

Collapse
No announcement yet.

Can't remove bad WD200

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tomgru
    replied
    Originally posted by prsmith777 View Post
    On HS3, I have had this problem.

    If you can see the device in Homeseer, go to Zwave then hit "test connectivity". Then try to remove bad node. Sometimes it takes a few trys to get this to work.

    If you already deleted the device from homeser, then go to Zwave controller management page and hit "Import Node Info from Controller and Scan Devices". This should bring back the device in question... then repeat above steps.

    Not sure if this is HS4
    thanks... that worked.

    Leave a comment:


  • Tomgru
    replied
    Crap... that still didn't work. Same error with new dimmer installed..

    Leave a comment:


  • prsmith777
    replied
    On HS3, I have had this problem.

    If you can see the device in Homeseer, go to Zwave then hit "test connectivity". Then try to remove bad node. Sometimes it takes a few trys to get this to work.

    If you already deleted the device from homeser, then go to Zwave controller management page and hit "Import Node Info from Controller and Scan Devices". This should bring back the device in question... then repeat above steps.

    Not sure if this is HS4

    Leave a comment:


  • Tomgru
    replied
    EDIT: more searching found similar. Going to try this:

    Install the new device, click on Replace Node and when the UI asks you, you will then send the inclusion signal on the new device.

    When done, the new device will have taken the place of the old device and all HS devices wil be retained.

    Leave a comment:


  • Tomgru
    started a topic Can't remove bad WD200

    Can't remove bad WD200

    Hey all... have a failed WD200 i'm trying to replace with identical unit. have tried "replace node", and "remove bad node", and get the following in the log.
    ZNetv2: Node 64 was not removed because the interface ZNetv2 does not have that node in its memory. (It may already be removed.)

    But in the znet node information, node 64 is clearly still there.

    Have also just tried to exclude... but doesn't seem to see the dimmer.

    Thoughts on how to remove/replace this that i missed?
Working...
X