I've been updating 2 switches with zflash+ 1.0.0.26, (v5.7 -> v5.13) it seems to work and took about 20 minutes each.
But after I'm not able to reach the device. Test connectivity nor rescan!
Tried to power off the breaker and back on, but still the same!
What should I do?
The switches work locally but not from HS.
Another switch was not seen from zflash+, so I try to flash it with the HS interface, but I don't think it work. Any step or special thing to do it that way?
I'm using z-net if that may be a problem?
Should I default reset those switches and re-include them?
Should I reflash them?
Thank you
But after I'm not able to reach the device. Test connectivity nor rescan!
Tried to power off the breaker and back on, but still the same!
What should I do?
The switches work locally but not from HS.
Another switch was not seen from zflash+, so I try to flash it with the HS interface, but I don't think it work. Any step or special thing to do it that way?
I'm using z-net if that may be a problem?
Should I default reset those switches and re-include them?
Should I reflash them?
Thank you
Comment