Announcement

Collapse
No announcement yet.

WS200+ Z-wave stopped working

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    WS200+ Z-wave stopped working

    Paddle works, but no remote control. Tried power reset. No communication. Tried rescan and that was successful, but still failed communication test.

    What steps do I need to remove it and try to include again? Is there a how-to somewhere?

    Thanks
    Barry


    #2
    Here's how I've done it so the node number stays the same and events don't have to be rebuilt. Steps are from memory but think it's enough to follow.

    1. Factory reset switch
    2. On device z-wave tab, run "Test connectivity" (should fail if factory reset was successful)
    3. On z-wave tab "Replace node"
    4. Put switch in inclusion mode
    5. Switch should be included using prior node number

    -Wade

    Comment


      #3
      Wade I can't get to the device z-wave tab. Something is corrupted. I am missing some devices completely. I'm going to try and load a backup prior to latest HS upgrade.
      Thanks,
      Barry

      Comment

      Working...
      X