WS200+ Not reachable after upgrade with ZFlash

[Guest]

I've been updating 2 switches with zflash+ 1.0.0.26, (v5.7 -> v5.13) it seems to work and took about 20 minutes each.

But after I'm not able to reach the device. Test connectivity nor rescan!
Tried to power off the breaker and back on, but still the same!
What should I do?

The switches work locally but not from HS.

Another switch was not seen from zflash+, so I try to flash it with the HS interface, but I don't think it work. Any step or special thing to do it that way?

I'm using z-net if that may be a problem?

Should I default reset those switches and re-include them?
Should I reflash them?

Thank you

[drhtmal]

I do not see a v5.13 for the WS200 switch. Did you possibly load the WD200 dimmer firmware on the WS200 switch?

I was looking at the downloads link here https://homeseer.com/current-downloads/ which does not have the v5.13 firmware for the WS200.

[Guest]

I do not see a v5.13 for the WS200 switch. Did you possibly load the WD200 dimmer firmware on the WS200 switch?

I was looking at the downloads link here https://homeseer.com/current-downloads/ which does not have the v5.13 firmware for the WS200.

I took it from here

https://forums.homeseer.com/mobiquo/...hp?pid=1244903

Looks it has a more recent version then the HS site.

Sent from my Pixel 3 XL using Tapatalk

[drhtmal]

When HomeSeer added group 2 association to the WD200 and WS200 back a few versions ago I recall there was an issue where you had to readd the device.

See post #1 here https://forums.homeseer.com/forum/ho...rmware-updates

Issues:

• When updating to this firmware the node ID of the switch will be lost. This was an unfortunate consequence of adding the group 2 association feature. You will need to add the switch back into your network. After adding the switch back in, click on the old device then Z-Wave tab, then "Remove Bad Node" to remove the node from the Z-Wave interface. If it fails, do a connectivity check, then remove.
• Make sure you install the WS200 file to a WS200 device and the WD200 file to a WD200 device otherwise you may brick the switch.
• The WS200 may show up as version 5.1 in HomeSeer after the update, this will be fixed in a future update.

[Guest]

When HomeSeer added group 2 association to the WD200 and WS200 back a few versions ago I recall there was an issue where you had to readd the device.

See post #1 here https://forums.homeseer.com/forum/ho...rmware-updates

Issues:

• When updating to this firmware the node ID of the switch will be lost. This was an unfortunate consequence of adding the group 2 association feature. You will need to add the switch back into your network. After adding the switch back in, click on the old device then Z-Wave tab, then "Remove Bad Node" to remove the node from the Z-Wave interface. If it fails, do a connectivity check, then remove.
• Make sure you install the WS200 file to a WS200 device and the WD200 file to a WD200 device otherwise you may brick the switch.
• The WS200 may show up as version 5.1 in HomeSeer after the update, this will be fixed in a future update.

I thought I have it done, but actually all I have done is remove because was added securely and re-include insecure to be able to flash it.
But will give a try to remove bad node and re-include it again, I've missed that part!
Will let you know 👍

Sent from my Pixel 3 XL using Tapatalk