Hi all, my z-wave controller died and I am migrating to a new one. I am struggling resetting the wd100+. I followed the instructions where its 3 presses up then 3 down and it is just not working. Are there any tricks to this? Thanks!
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment