HS-FLS100+ behavior on HS2+ Ztroller
Hi. I've been away from this forum for a loooong time. I'm still running HS2 with a Ztroller. System has been rock solid since HS2 came out, so I haven't upgraded. In the process of replacing my very old PIR X10 motion floods with these. Got one in today to try it out. Got it paired with HS2, able to control lights from HS2, but not able to set any of the parameters for Lux or the Timer. Unit is acting like it is in test mode (lights on with motion, off in 15 seconds with immediate reset of PIR). I did move the dials back away from the full clockwise settings (e.g. "T"). No difference in behavior. HS reports on/off correctly but not Lux or Motion values. So now I'm wondering, and have seen little discussion on this here - are these puppies compatible with HS2+Ztroller? I don't need the advanced security features, but would really like to get these Lux and Timers settings right.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment