Every 3 minutes I get a 'no event', followed by a 'motion detected'. All day and night long. I covered the sensor and still get it. Any thoughts?
I have set parameter 5 to 0.
I have set parameter 5 to 0.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
Network and Node ID | xxxxxxxx, 8 | Manufacturer | HomeSeer Technologies LLC (ID=0xC) | ||
Product Type | 0x201 | Product ID | 0xC | ||
Z-Wave Plus Node Type | ZWP Node | Z-Wave Plus Role Type | Always On Slave | ||
Supports Status | Yes | Library Type | Enhanced Routing Slave | ||
Z-Wave Lib Version | 6.08 (Unknown) | Application Version | 1.0 | ||
Hardware Version | 1 | Firmware 0 Version | 0.6 | ||
Associated Device | PatioSensors FARSIDE Motion Sensor N#8 Cmd Class: Notification Cmd Class Version: 8 |
Associated Device | PatioSensors FARSIDE Temperature N#8 Cmd Class: Sensor Multilevel Cmd Class Version: 5 |
||
Associated Device | PatioSensors FARSIDE Luminance N#8 Cmd Class: Sensor Multilevel Cmd Class Version: 5 |
Associated Device | PatioSensors FARSIDE Switch N#8 Cmd Class: Switch Binary Cmd Class Version: 1 |
||
Firmware Update Command Class Version |
4 | Association Groups | (2) = 1, 2 | ||
Association Group 1 | Max=1, Nodes=1 | Association Group 2 | Max=4, Currently Empty | ||
Neighboring Nodes | One Neighbor: 4 |
Comment