Couldn't figure out why our sensors weren't recognizing changes to the On Time and Lux parameters. Turns out the units ignore Z-Wave settings by design if the dials are in the fully counterclockwise "Walk Test" position. The instructions suggest placing these in mid-position, but it isn't clear that it is actually a requirement that they be set somewhere other than fully counterclockwise. Since we were going to control via Z-Wave, we (incorrectly) assumed we could leave them in the test positions. Matt said they would update the instructions to make that clearer.
Announcement
Collapse
No announcement yet.
Move dials out of T and * position if Z-Wave control is desired
Collapse
X
Comment