Announcement

Collapse
No announcement yet.

Using Serial to send commands

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Using Serial to send commands

    I just recently bought a Zee and I'm trying to control my small z-wave network via rs232. I bought a Leviton VRC0P rf+ plug-in serial module to do this with.

    I got the device to work on the network and all that. Can plug my computer's com port and start sending commands and it responds (although still not giving me any feedback), but it works ok. But I'm trying to get it to work over a serial port from a Pro Control ProLink24.z. I can see the gateway sending the commands, but the Leviton piece doesn't seen to respond. Leviton's tech support has been less than helpful in this regard.

    I'm not married to this Leviton piece, I'm still not sure if it's even working correctly. Any idea what I'm doing wrong or is there something else better suited to do this?

    Thanks!
Working...
X