How do you add speaker clients to the HomeTroolerZEE. Found the network port box under Tools, setup, and network with a default of 10401. I entered LAN IP address for the WFTT07 but so far..no cigar.
Announcement
Collapse
No announcement yet.
ZEE speaker clients
Collapse
X
-
You actually dont need to do anything on the server side. Just point your WFTT07 to your HS server. Any 'speak' actions on the HS server will be sent to the client.HS4Pro on a Raspberry Pi4
54 Z-Wave Nodes / 21 Zigbee Devices / 108 Events / 767 Devices
Plugins: Z-Wave / Zigbee Plus / EasyTrigger / AK Weather / OMNI
HSTouch Clients: 1 Android
-
On the WFTT07, launch HSTouch if not already running.
Select the settings - probably located on the bottom-right.
Select an empty Server slot - like Server 1.
Enter the IP Address for your HS Server.
Enter the username/password (usually default/default).
Leave the port as 10200.
Stop/restart the HSTouch client.
You should be connected at that point.HS4Pro on a Raspberry Pi4
54 Z-Wave Nodes / 21 Zigbee Devices / 108 Events / 767 Devices
Plugins: Z-Wave / Zigbee Plus / EasyTrigger / AK Weather / OMNI
HSTouch Clients: 1 Android
Comment
-
No the Zee uses the Flite TTS Engine. Rob answered this same question earlier about a voice here:
http://board.homeseer.com/showthread...38#post1137238
Comment
Comment