How do you add speaker clients to the HomeTroolerZEE. Found the network port box under Tools, setup, and network with a default of 10401. I entered LAN IP address for the WFTT07 but so far..no cigar.
-
-
You actually dont need to do anything on the server side. Just point your WFTT07 to your HS server. Any 'speak' actions on the HS server will be sent to the client.HS4Pro on a Raspberry Pi4
54 Z-Wave Nodes / 21 Zigbee Devices / 108 Events / 767 Devices
Plugins: Z-Wave / Zigbee Plus / EasyTrigger / AK Weather / OMNI
HSTouch Clients: 1 Android -
rmasonjr...thanks for reply.
How do you point the WFTT07 to the HomeTrollerZee. They are both connected to my router. I have forwarded the zee's ip address to a port for outside my LAN connections.Comment
-
On the WFTT07, launch HSTouch if not already running.
Select the settings - probably located on the bottom-right.
Select an empty Server slot - like Server 1.
Enter the IP Address for your HS Server.
Enter the username/password (usually default/default).
Leave the port as 10200.
Stop/restart the HSTouch client.
You should be connected at that point.HS4Pro on a Raspberry Pi4
54 Z-Wave Nodes / 21 Zigbee Devices / 108 Events / 767 Devices
Plugins: Z-Wave / Zigbee Plus / EasyTrigger / AK Weather / OMNI
HSTouch Clients: 1 AndroidComment
-
It's working....
Works great.
Thanks rmasonjr..Comment
-
Changing Voices
I have all kinds of voices that I had for HS2 pro. Can those go on HomeTroller Zee. Would love to get rid of that awful voice.danielboComment
-
No the Zee uses the Flite TTS Engine. Rob answered this same question earlier about a voice here:
http://board.homeseer.com/showthread...38#post1137238Comment
Comment