Announcement

Collapse
No announcement yet.

flakey temp

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • flakey temp

    In looking through my log I saw the following entries during a time when no one was home:
    1/25/2011 4:59:19 PM Device Update Device: 2nd Floor Stairway ZMulti Temp value set to 64.5 (6450/F)
    1/25/2011 4:59:21 PM Device Update Device: 2nd Floor Stairway ZMulti Temp value set to 70.9 (7090/F)

    The temp was actually around 70 but within a few seconds changed 5 degrees. This brings up reliability concerns with the whole sensor!

  • #2
    Is the sensor near an A/C vent or in direct sunlight? That might cause some false readings.
    HS3Pro Running on a Raspberry Pi3
    64 Z-Wave Nodes, 168 Events, 280 Devices
    UPB modules via OMNI plugin/panel
    Plugins: Z-Wave, BLRF, OMNI, HSTouch, weatherXML, EasyTrigger
    HSTouch Clients: 3 Android, 1 Joggler

    Comment


    • #3
      No not near direct sunlight and not even close to any vent.
      I also just saw this in the log today with no one home and pretty constant light between the times listed whicgh are EST.
      1/27/2011 1:48:22 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 6 (600/%)
      1/27/2011 2:00:40 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 3 (300/%)
      1/27/2011 2:12:59 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 2 (200/%)
      1/27/2011 2:25:17 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 6 (600/%)
      1/27/2011 2:37:35 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 5 (500/%)
      1/27/2011 2:49:53 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 8 (800/%)
      1/27/2011 3:02:11 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 1 (100/%)
      1/27/2011 3:26:48 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 2 (200/%)
      1/27/2011 3:39:06 PM Device Update Device: 2nd Floor Stairway ZMulti Lum value set to 0 (0/%)

      Comment


      • #4
        How about the batteries - are they relatively new?
        HS3Pro Running on a Raspberry Pi3
        64 Z-Wave Nodes, 168 Events, 280 Devices
        UPB modules via OMNI plugin/panel
        Plugins: Z-Wave, BLRF, OMNI, HSTouch, weatherXML, EasyTrigger
        HSTouch Clients: 3 Android, 1 Joggler

        Comment

        Working...
        X