OK - new to z-wave. Did my best at following the HSM100 instructions using the Z-troller to add these devices. Both units added 3 of the 4 nodes and work correctly (motion, light & battery) but both failed to add the temp node. The units are reporting back to HSPro but without a node ID the following error is recorded.
9/25/2013 9:36:55 AM - Error - (2) Sensor Multilevel Report for type Temperature received, but the corresponding device Node ID cannot be found.(2) Node/Instance=2/-1
May I please get your input on how to get the system to add the 4th node for temp.
THANK YOU!
9/25/2013 9:36:55 AM - Error - (2) Sensor Multilevel Report for type Temperature received, but the corresponding device Node ID cannot be found.(2) Node/Instance=2/-1
May I please get your input on how to get the system to add the 4th node for temp.
THANK YOU!
Comment