Question is when I go into the Node Info and the list shows up but Node 1 does not show any info. See pic. I think the smartstick+ device was deleted a while back thinking it was not need because the HUBSZB-1 was now the controller. Yes, I know, stupid. I didn't know they were one in the same. So how do I get this fixed so the Node 1 controller shows the correct info? TIA
-
Controller Missing Node Info
😞I switched my controller to the HUBSZB-1 from a smartstick+. I tried following the steps given and finally got the HUBSZB-1 to accept the z-wave node info and is working. Zigbee another situation.
Question is when I go into the Node Info and the list shows up but Node 1 does not show any info. See pic. I think the smartstick+ device was deleted a while back thinking it was not need because the HUBSZB-1 was now the controller. Yes, I know, stupid. I didn't know they were one in the same. So how do I get this fixed so the Node 1 controller shows the correct info? TIA