I run my house on a Z-NET as the main interface. I then took my old Z-Troller and installed it out by the pool as this is too far for most devices to get to the Z-NET. I paired all of the devices around the pool with the Z-Troller.
I was doing some maintenance today and I noticed one device in a bedroom - originally paired to the Z-NET is now showing paired to the Z-Troller. Also I see one device at the pool, the pool pump, originally paired to the Z-Troller is now paired to the Z-NET.
Also, in node information I see the message "(May change next Optimize)". So presumably during an optimize it has reassigned these devices. Can I stop that?
How do I reassign these devices back to the correct interface - can you do that with Z-Tools? I don't want to go messing around until I am sure. Thanks.
I was doing some maintenance today and I noticed one device in a bedroom - originally paired to the Z-NET is now showing paired to the Z-Troller. Also I see one device at the pool, the pool pump, originally paired to the Z-Troller is now paired to the Z-NET.
Also, in node information I see the message "(May change next Optimize)". So presumably during an optimize it has reassigned these devices. Can I stop that?
How do I reassign these devices back to the correct interface - can you do that with Z-Tools? I don't want to go messing around until I am sure. Thanks.
Comment