Question about implementing UZB Z-Wave interface in Z-Net

[Richel]

I have an old Z-Net with an old Z-Wave library, which I think cannot be upgraded. I also have a HomeSeer SmartStick+ with a newer Z-Wave library. I plugged my SmartStick+ into my Z-Net and it was recognized fine at start up (I connected a monitor to the Z-Net to see the boot up). I added this Z-Net + SmartStick+ as a new network in HomeSeer HS4, but the Controller Node Information did not indicate that it had a UZB device. So, I'm wondering how to get this done (or I may be all wrong about this implementation). Thanks.

EDIT: I went through the process again of adding the Z-NET with the SmartStick+ and now the library version is consistent with having the SmartStick+ implemented.