I want to remove all the nodes from my z-wave network and start from scratch. I tried the erase function under controller mgmt-->z-wave interface-->ERASE interface.
Whole bunch of scary warnings but nothing really changed.
How do I perform a factory reset to get back to a fresh start and remove all of the nodes so I can re-add them to the network and clean everything up.
Thanks in advance.
TL
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.