My Zee S2 SD card failed. While replacing it, I managed to detach the daughter board. Can anyone confirm that the pin alignment should be that the first pins on the mainboard attach to the first sockets on the daughter board? This seemed like the most logical and it does appear to align the hole in the board with the hole for the machine screw holding the case together.
I'm running into zwave controllers errors in the log after bringing the zee back up with the new card, I/O errors to COM1, power to the zwave controller errors, complaints that only a single device can connect to an Ethernet interface, etc. None of my zwave nodes are viewable, I'm seeing multiple networks created with the same homeid, just endless issues with the controller really.
Thanks for any help!
I'm running into zwave controllers errors in the log after bringing the zee back up with the new card, I/O errors to COM1, power to the zwave controller errors, complaints that only a single device can connect to an Ethernet interface, etc. None of my zwave nodes are viewable, I'm seeing multiple networks created with the same homeid, just endless issues with the controller really.
Thanks for any help!
Comment