No announcement yet.

New devices seem to be saved in the database improperly.

  • Filter
  • Time
  • Show
Clear All
new posts

  • New devices seem to be saved in the database improperly.

    Since installing, I have noticed some strange behavior. I have installed 4 devices, 2 HS-DS100+ door sensors and 2 HS-WS200+ switches. These devices installed without incident, but I notice that they remain in the "Floor" drop-down box as Node "X". Under PLUG-INS >Z-WAVE>NODE INFORMATION the devices show as properly renamed and under VIEW > DEVICE MANAGEMENT they show properly under "Floor" and "Room" appropriately selected, yet do NOT show if Node [X1 - X4] is selected.

    Building an event, the devices are noted as NODE [X] in the device name drop down list and the device name (as renamed) does not appear.

    I've reported this to HS support, but has anyone else seen this behavior?
    Attached Files
    HomeSeer Version: HS3 Pro Edition
    Operating System: Microsoft Windows 10 Pro - Work Station

    Enabled Plug-Ins: AmbientWeather | BLLock | BLUPS | Device History | EasyTrigger | MeiHarmonyHub | 3.0.6681.34300: UltraCID3 | 3.0.6644.26753: UltraLog3 | 3.0.6554.33094: UltraMon3 | weatherXML | Z-Wave | 3.0.51: HS Touch Designer | Z-Seer+