Since installing 3.0.0.500, I have noticed some strange behavior. I have installed 4 devices, 2 HS-DS100+ door sensors and 2 HS-WS200+ switches. These devices installed without incident, but I notice that they remain in the "Floor" drop-down box as Node "X". Under PLUG-INS >Z-WAVE>NODE INFORMATION the devices show as properly renamed and under VIEW > DEVICE MANAGEMENT they show properly under "Floor" and "Room" appropriately selected, yet do NOT show if Node [X1 - X4] is selected.

Building an event, the devices are noted as NODE [X] in the device name drop down list and the device name (as renamed) does not appear.

I've reported this to HS support, but has anyone else seen this behavior?
.
Attached Files