I am new to HomeSeer and still learning. I have a status event for my garage door. It works correctly for the "open" status but it doubles the event for "closed" status. On the double event it does the first event at the time when the sensor changes state but then it repeats the event 10 seconds later.
Nov-28 8:05:36 Pushover 3P Pushover Notification Sent - Message Title Garage-Closed
Nov-28 8:05:35 Event Event Trigger "Garage Door Control Garage Door Status"
Nov-28 8:05:26 Pushover 3P Pushover Notification Sent - Message Title Garage-Closed
Nov-28 8:05:25 Event Event Trigger "Garage Door Control Garage Door Status"
Nov-28 8:05:25 Z-Wave Device: Garage Node 18 Sensor Binary Set to Off/Closed/No Motion
Nov-28 7:59:22 Pushover 3P Pushover Notification Sent - Message Title Garage-Open
Nov-28 7:59:22 Event Event Trigger "Garage Door Control Garage Door Status"
Nov-28 7:59:22 Z-Wave Device: Garage Node 18 Sensor Binary Set to On/Open/Motion
Nov-28 8:05:36 Pushover 3P Pushover Notification Sent - Message Title Garage-Closed
Nov-28 8:05:35 Event Event Trigger "Garage Door Control Garage Door Status"
Nov-28 8:05:26 Pushover 3P Pushover Notification Sent - Message Title Garage-Closed
Nov-28 8:05:25 Event Event Trigger "Garage Door Control Garage Door Status"
Nov-28 8:05:25 Z-Wave Device: Garage Node 18 Sensor Binary Set to Off/Closed/No Motion
Nov-28 7:59:22 Pushover 3P Pushover Notification Sent - Message Title Garage-Open
Nov-28 7:59:22 Event Event Trigger "Garage Door Control Garage Door Status"
Nov-28 7:59:22 Z-Wave Device: Garage Node 18 Sensor Binary Set to On/Open/Motion
Comment