I want to run a event in case HS3 reboots or has a power loss and reboots because of that. I just need to make sure that power to my Z-Net is restored. I use a LightwaveRF module to be able to power cycle my Z-Net when that draeded Z-wave error occurs. Unfortunately the module will not remember the state it was in, so when power is cut it stays off. And obviously being LightwaveRF there is no feedback...
Announcement
Collapse
No announcement yet.
How do I trigger an event on reboot / Power loss ?
Collapse
X
-
Take a look at this thread for some additional ideas: http://board.homeseer.com/showthread.php?t=181848
Cheers
AlHS 4.2.8.0: 2134 Devices 1252 Events
Z-Wave 3.0.10.0: 133 Nodes on one Z-Net
Comment
Comment