I've had my setup up and running for a couple of months now and I was hoping by fiddling about with my light automation I could eliminate the delay I'm experiencing.
Below is an image of my events and my aeotec Multisensor parameter configuration.
I would appreciate it if someone could take a look and see if there's an issue with my logic or if its just an rf interference or process delay.
I read you can link devices to remove a communication delay but with the events I have set I'm unsure as to how that would work.
Below is an image of my events and my aeotec Multisensor parameter configuration.
I would appreciate it if someone could take a look and see if there's an issue with my logic or if its just an rf interference or process delay.
I read you can link devices to remove a communication delay but with the events I have set I'm unsure as to how that would work.
Comment