I have about 50 Dimmer 2 units with quite a few events that control them. In many cases, 5 or 6 modules will get commands at the same time.
In looking at the logs, it appears that there's a huge amount of Z-Wave traffic related to power / energy reports that's slowing things down. I'd like to be able to stop this traffic.
I've tried setting the 3 parameters listed in the Fibaro manual to "disabled", but it doesn't make any difference:
Parameter 50 to 0 (1 byte)
Parameter 52 to 0 (2 bytes)
Parameter 53 to 0 (2 bytes)
Any idea on what else I can try?
In looking at the logs, it appears that there's a huge amount of Z-Wave traffic related to power / energy reports that's slowing things down. I'd like to be able to stop this traffic.
I've tried setting the 3 parameters listed in the Fibaro manual to "disabled", but it doesn't make any difference:
Parameter 50 to 0 (1 byte)
Parameter 52 to 0 (2 bytes)
Parameter 53 to 0 (2 bytes)
Any idea on what else I can try?