HS3 on Linux - No Firmware Update Option

[mikeyd810]

I'm doing a trial of the HS3 software and looking at my HS-WD100+ and no firmware update option shows up when I'm in the Zwave tab. The current dimmer is running 5.17, wondering if there's something simple I missed. I searched around for a good bit and haven't found anything that points to a similar issue.

Current Date/Time: 11/15/2017 1:20:56 PM
HomeSeer Version: HS3 Pro Edition 3.0.0.368
Linux version: Linux mint-vm 4.4.0-98-generic #121-Ubuntu SMP Tue Oct 10 14:24:03 UTC 2017 x86_64 x86_64 x86_64 GNU/Linux System Uptime: 0 Days 16 Hours 15 Minutes 11 Seconds
IP Address: 192.168.1.120
Number of Devices: 50
Number of Events: 2
Available Threads: 394

Enabled Plug-Ins
3.0.0.20: Ecobee
1.1.17301.270: MyQ
3.0.6104.19146: UltraRachio3
3.0.1.130: Z-Wave

[integlikewhoa]

I'm doing a trial of the HS3 software and looking at my HS-WD100+ and no firmware update option shows up when I'm in the Zwave tab. The current dimmer is running 5.17, wondering if there's something simple I missed. I searched around for a good bit and haven't found anything that points to a similar issue.

The firmware is right here:

https://homeseer.com/current-downloads/

Z-flash is what I use, but I have used the Z-wave tab and selected the file from above to update single units.

[mikeyd810]

The firmware is right here:

https://homeseer.com/current-downloads/

Z-flash is what I use, but I have used the Z-wave tab and selected the file from above to update single units.

Yeah I have the updated firmware file for 5.19 but without the firmware update option for the root devices in HS3 it's not useful.

I attached a picture of what I'm seeing in the zwave tab for the root device of the dimmer.

[Rupp]

This option has been removed from later versions and is now available in Z-Flash available on the HomeSeer downloads page.
https://homeseer.com/current-downloads/

[Kerat]

HS3 on Linux - No Firmware Update Option

I'm doing a trial of the HS3 software and looking at my HS-WD100+ and no firmware update option shows up when I'm in the Zwave tab.

I am on the beta 3.0.0.382 and it is there. This is my original install and was patched from 3.0.0.25x

Each Zwave device will have multiple devices connected to it in the home tab.



You need to find the root device (gear icon) for the physical Zwave device you are trying to patch.



Then open the "Zwave" tab, then expand the "Firmware update".

Have you looked there?


Sent from my iPhone using Tapatalk

[mikeyd810]

This option has been removed from later versions and is now available in Z-Flash available on the HomeSeer downloads page.
https://homeseer.com/current-downloads/

Thanks, I was able to update after reverting to an earlier release.

[rhcev3@gmail.com]

Is this manual one at a time "sneaker-net" the only option for users running on Linux????