No announcement yet.

Power Failure & Nodes Now Unreachable

  • Filter
  • Time
  • Show
Clear All
new posts

  • Power Failure & Nodes Now Unreachable

    We had a long power failure of about 10 hours
    After regaining power and restarting HS3, all my Z wave devices were missing. I found an old forum thread that talked about deleting the old data file that was smaller, which then bought all the existing nodes back into homeseer - this worked, but I still can't reach the nodes, Oddly enough they all seem to be hardwired switching nodes - EG light switches, all the sensors are reporting through Z wave fine.

    Does anyone have any thoughts? I have about 70-80 nodes and going through and manually re-adding them seems excessive