Hi folks - I'm having issues with two door sensors I bought to monitor whether a garage fridge was left open.
At first I installed them flush with the door edge and fridge edge, which left about a 1cm gap between them. They weren't always firing closed, so I pulled up and then put them right next to each other as per the picture attached. Unfortunately, even like this I'm having an issue where they don't always report closed.
Maybe it's due to a very minimal bounce the doors can have sometimes when they close as they suction shut? Anyone have ideas?
At first I installed them flush with the door edge and fridge edge, which left about a 1cm gap between them. They weren't always firing closed, so I pulled up and then put them right next to each other as per the picture attached. Unfortunately, even like this I'm having an issue where they don't always report closed.
Maybe it's due to a very minimal bounce the doors can have sometimes when they close as they suction shut? Anyone have ideas?
Comment