I'm hoping someone can point me in the right direction.
I have a pressure transducer attached to a Mimolite. The output of the Mimolite just gives my raw data.
Therefore, I needed to convert that raw data into a meaningful psi reading.
They way i did it was under Status Graphic, I edited the Stats Text for device.
I entered the different ranges of output from the mimolite and associated it with a specific PSI.
I had about 10 entries - precision was not necessary.
It worked great for about a month but then the ranges i specified all disappeared and the entire section under Status Text reverted back to its original settings which is one entry for the entire range of values. .
So I have 2 questions..
1. Is it acceptable to make the conversion this way?
2. If it is acceptable, how do I make the settings permanent or can i at least back them up?
Thanks
Joe
I have a pressure transducer attached to a Mimolite. The output of the Mimolite just gives my raw data.
Therefore, I needed to convert that raw data into a meaningful psi reading.
They way i did it was under Status Graphic, I edited the Stats Text for device.
I entered the different ranges of output from the mimolite and associated it with a specific PSI.
I had about 10 entries - precision was not necessary.
It worked great for about a month but then the ranges i specified all disappeared and the entire section under Status Text reverted back to its original settings which is one entry for the entire range of values. .
So I have 2 questions..
1. Is it acceptable to make the conversion this way?
2. If it is acceptable, how do I make the settings permanent or can i at least back them up?
Thanks
Joe
Comment