Log "noise" due to power level changes

[GadgetBoySI]

Go to the device management page and for the device, the configuration tab then select the check box "Do not log commands from this device".

This is common for power monitoring devices.

Robert

Thanks - I did that previously, but for the switch only. The device actually sets up multiple devices within Homeseer. I think I checked that now for the right device.

Thanks again.

[langenet]

Go to the device management page and for the device, the configuration tab then select the check box "Do not log commands from this device".

This is common for power monitoring devices.

Robert

[GadgetBoySI]

I have the follow device on my system.

https://www.z-wave.com/shop-z-wave-s...sb-charge-port

This device is posting to my log every 30 seconds the power draw on the device. It's really annoying. Is there a way to disable having to log every change?

Ex:

Jun-26 9:37:22 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.535 (1.535 Watts)

Jun-26 9:36:52 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.549 (1.549 Watts)

Jun-26 9:36:22 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.552 (1.552 Watts)

Jun-26 9:35:52 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.562 (1.562 Watts)

Jun-26 9:35:22 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.543 (1.543 Watts)

Jun-26 9:34:52 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.564 (1.564 Watts)

Jun-26 9:34:22 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.568 (1.568 Watts)

Jun-26 9:33:52 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.563 (1.563 Watts)

Jun-26 9:33:22 AM

Z-Wave

Device: Node 65 Z-Wave Watts Set to 1.574 (1.574 Watts)

Thanks!