I have two of those Vision Z-Wave In-Wall double relay switches that Smartest House sells (ZL 7432US).
According to the documentation, I need to change parameter 2 to value 02 so that the switches work correctly with momentary switches, but on the Z-Wave tab in the device menu in Homeseer, there is no option to set parameters - only the option to set behaviour for ALL ON/ALL OFF commands.
All my other Z-Wave devices have parameter options. Is this a problem with the Vision switch's firmware? (I've done a re-scan with no luck).
Is there any other way to manually send a parameter value to the device?
According to the documentation, I need to change parameter 2 to value 02 so that the switches work correctly with momentary switches, but on the Z-Wave tab in the device menu in Homeseer, there is no option to set parameters - only the option to set behaviour for ALL ON/ALL OFF commands.
All my other Z-Wave devices have parameter options. Is this a problem with the Vision switch's firmware? (I've done a re-scan with no luck).
Is there any other way to manually send a parameter value to the device?
Comment