Hello,
My logs are full of the message below that come every second.
In ProcessEventItem, Cannot process event poll check, there are no actions.
I have disabled and web-enabled zwave, restarted the unit, and disabled the zwave plug in polling option. I suspect it may have something to do with the cold snap last night causing one or more battery powered devices in my garage or porch to flake out when their voltage dropped but I am otherwise at a loss.
Edit: one of my zwave light switches on an exterior wall was clicking. I turned off the breaker, still got the log messages. I removed that node from homeseer, still get the error messages. Disabled very plug in, one at a time. Still get error messages. Did a total shutdown, even pulled the power cord for 10s before rebooting, still get the message. Updated every plugin that had one available, no change.
Maddening!
Any ideas?
My logs are full of the message below that come every second.
In ProcessEventItem, Cannot process event poll check, there are no actions.
I have disabled and web-enabled zwave, restarted the unit, and disabled the zwave plug in polling option. I suspect it may have something to do with the cold snap last night causing one or more battery powered devices in my garage or porch to flake out when their voltage dropped but I am otherwise at a loss.
Edit: one of my zwave light switches on an exterior wall was clicking. I turned off the breaker, still got the log messages. I removed that node from homeseer, still get the error messages. Disabled very plug in, one at a time. Still get error messages. Did a total shutdown, even pulled the power cord for 10s before rebooting, still get the message. Updated every plugin that had one available, no change.
Maddening!
Any ideas?
Comment