I installed a new switch and since my network was a bit wonky, I backed it up, restored it, and then restarted the interface to clear all old routes.
I optimized only one device, the new switch since it was in the middle of the house. I was able to reach all but one device.
Anyway, using z-seer, I noted the few Z wave plus devices are routing through the non-plus devices, which explains the sluggish behavior.
I don't really want to manually create routes because that defeats the purpose of a mesh network. Is there a way I can tell homeseer not to create routes through old devices?
Thanks,
Devan
I optimized only one device, the new switch since it was in the middle of the house. I was able to reach all but one device.
Anyway, using z-seer, I noted the few Z wave plus devices are routing through the non-plus devices, which explains the sluggish behavior.
I don't really want to manually create routes because that defeats the purpose of a mesh network. Is there a way I can tell homeseer not to create routes through old devices?
Thanks,
Devan