The DSC panel reports corrects in HS2 but does not report correctly in HS3. DSC 64 zone panel connected via serial to IT100. The panel does arm and disarm but events wont trigger due to incorrect starts reporting .
"Panel Status: This displays any trouble status with the panel such as low battery. (IT100 only) The value of this device holds the last code that was sent to this zone. For example, if the partition goes into the alarm state, the value will be 654. The exception to this is when the partion is armed. The code has extra information that says how the partition was armed. The codes are:
1652 = Armed Away
1653 = Armed Stay
1654 = Armed Away No Delay
1655 = Armed Stay No Delay"
It reports 300 to 304 respectfully . It also has the same bug HS2 has, after 15 years still not resolved, of reporting Force Armed when it should report code for disarmed .
No reply from HS ticket because "they are too busy working on hs4"
really hoping for any help .thanks.
"Panel Status: This displays any trouble status with the panel such as low battery. (IT100 only) The value of this device holds the last code that was sent to this zone. For example, if the partition goes into the alarm state, the value will be 654. The exception to this is when the partion is armed. The code has extra information that says how the partition was armed. The codes are:
1652 = Armed Away
1653 = Armed Stay
1654 = Armed Away No Delay
1655 = Armed Stay No Delay"
It reports 300 to 304 respectfully . It also has the same bug HS2 has, after 15 years still not resolved, of reporting Force Armed when it should report code for disarmed .
No reply from HS ticket because "they are too busy working on hs4"
really hoping for any help .thanks.
Comment