Hello,
I recently got a Z-Uno (a zwave device that can be programmed similarly to an arduino) and have been trying to use it for an irrigation system that require 15 relays. I have already verified that the relay works and that my sketch works but I am having issues with HS3 potentially sending incorrect commands to incorrect channels. Effectively, if I have 15 boolean switches associated with the device, the first 7 work fine, the 8th switch does nothing, and the next seven switches start triggering the first 7 relays/channels. Any idea what could be causing the issue as the Z-Uno developer said that this a problem with HS3? My Z-Uno code is attached but keep mind only 10 channels are currently active, but the problem still exists.
Current Setup:
HS3 - 3.0.0.548
Z-Troller
Z-Uno w/ 2.1.5
I recently got a Z-Uno (a zwave device that can be programmed similarly to an arduino) and have been trying to use it for an irrigation system that require 15 relays. I have already verified that the relay works and that my sketch works but I am having issues with HS3 potentially sending incorrect commands to incorrect channels. Effectively, if I have 15 boolean switches associated with the device, the first 7 work fine, the 8th switch does nothing, and the next seven switches start triggering the first 7 relays/channels. Any idea what could be causing the issue as the Z-Uno developer said that this a problem with HS3? My Z-Uno code is attached but keep mind only 10 channels are currently active, but the problem still exists.
Current Setup:
HS3 - 3.0.0.548
Z-Troller
Z-Uno w/ 2.1.5
Comment